Specialized contractor · RBQ 5839-3208-01 · APCHQ · IKO RoofPro 1 877 445-4610 · Credit available
Service · Cathedral ceiling

Cathedral ceiling insulation with spray foam

Flat roofs too: spray foam insulates and stops air where a ventilated attic has no place.

In a cathedral ceiling or a flat roof, spray foam insulates, stops air and holds back vapour in a single application, at about R-6 per inch. Rénoclimat 2026 provides $1.75 per sq. ft. for a roof brought to R-40 in total, of which R-20 added: you need 7 in. of spray foam if there is no other insulation, over at least 300 sq. ft.

Updated November 11, 2026 · An expert measures at your home, then hands you a detailed, firm-price quote.

What does spray foam do in a cathedral ceiling?

We spray foam into cathedral ceilings and flat roofs, where a ventilated attic has no place. Spray foam (also called spray polyurethane foam) insulates, stops air and holds back vapour in a single application, at about R-6 per inch. The full technique is in our spray foam guide for basements and crawl spaces.

A cathedral ceiling seen from below: both slopes sprayed between the rafters, the tie beams exposed and scaffolding below
A cathedral ceiling · both slopes sprayed between the rafters, the tie beams exposed, scaffolding below.
A sloped ceiling sprayed over its whole surface, with the low knee wall sprayed between its studs
A sloped ceiling · sprayed over its whole surface, with the low knee wall sprayed between its studs.
A flat roof opened from above: spray foam applied between the joists, four workers at work
A flat roof · opened from above, spray foam between the joists, four workers apply the next section.
The underside of a roof sprayed between the trusses, seen from inside the attic space
The underside of a roof · sprayed between the trusses, seen from inside the attic space.

What thickness for a cathedral ceiling?

Rénoclimat requires R-40 in total, of which R-20 added. With no other insulation, you need 7 in. of spray foam at about R-6 per inch, which is about R-42. If some insulation that counts is left in place, you need less. The Airmétic Soya HP data sheet gives R-25.6 at 4 in., R-18.5 at 3 in. and R-11.7 at 2 in. (CAN/ULC-S770 test). It is a calculation, not a promise: we confirm it with you before the work, and the thickness is written in the quote.

What Rénoclimat provides for a cathedral ceiling or a flat roof

Since October 1, 2026, Rénoclimat pays by the square foot, with no energy assessment, for work done by an RBQ-licensed contractor (us: RBQ 5839-3208-01) who signs the compliance certificate. The estimated grant is the lesser of the amount paid before taxes and the schedule's amount. LogisVert does not cover spray foam: here, Rénoclimat is the program.

The 2026 schedule for the roof
WorkR-valueMinimum areaEstimated grant
Cathedral ceiling or flat roofR-20 added, R-40 in total (7 in. of spray foam alone)300 sq. ft.$1.75 per sq. ft.
AtticR-20 added, R-60 in total300 sq. ft.$1.75 per sq. ft.

For a house, the cap is $2,000 for the whole roof, attic included, and $5,000 for a duplex, a triplex or an apartment building. At $1.75 per sq. ft., it is reached at 1,143 sq. ft. If the roof has several types, the amount is calculated pro rata.

What does not count

  • Less than R-40 in total or than R-20 added. Under these values, the estimated grant is zero.
  • Under 300 sq. ft. A smaller roof earns nothing.
  • An addition or a house that is less than 5 years old.
  • Work done before October 1, 2026, done yourself, or done by a contractor without the right RBQ licence.
  • A category already paid or refused. Since October 1, 2026, there is only one grant per category, and the roof is one.

Calculate the estimated grant for my roof

Rénoclimat's online application portal is not open yet (Québec.ca: under development, for this fall). Keep the itemized invoice, the signed compliance certificate and photos of the work: the application is due within 12 months of the end of the work.

An example calculation

Here is a calculation, not a job: 700 sq. ft. of cathedral ceiling brought to R-40.

Area counted
700 sq. ft. (the minimum is 300 sq. ft.)
Target value
R-40 in total, which is 7 in. of spray foam if there is no other insulation
Schedule
$1.75 per sq. ft.
Grant estimated under the schedule
700 sq. ft. × $1.75 = $1,225
Cap
$1,225 stays under the $2,000 cap for a house, shared with the attic

The calculator on the Rénoclimat page redoes this calculation with your measurements and says what is missing, in inches or in square feet.

How does the job go?

  1. 1

    The visit and measurements

    An expert measures at your home (visit within 24 to 48 hours) and hands you a detailed, firm-price quote on the spot.

  2. 2

    Protecting the premises

    We mask and protect the surfaces around the area.

  3. 3

    The application

    Our certified applicators track the mix, the temperature and the thickness of each pass.

  4. 4

    Checking and the report

    We measure the thickness applied, then give you an end-of-work report with photos. For Rénoclimat, we sign the compliance certificate, and the invoice itemizes areas, thicknesses and R-values.

What should you know before the work?

  • Plan to leave the house with the family and pets during the application, then for at least 25 hours (Airmétic Soya HP data sheet).
  • Spray foam gets covered with a code-compliant thermal barrier, drywall for example: the quote states the covering and who installs it.

The rest is in the guide.

When is spray foam not the right answer?

For an accessible attic, we recommend blown insulation (see attic insulation). For a roof, spray foam is not the right answer either in these cases:

  • A contaminant is present (vermiculite, asbestos, active mould). It comes out first, never under the foam.
  • The wood is soaked. The manufacturer requires wood at 19% moisture or less when spraying: it has to dry first.

What warranty covers the work?

The spray foam work is warranted for 2 years, in writing, and the product is covered by its manufacturer's warranty. The details are on our warranties page.

Keep reading

Sources: Rénoclimat Participant's Guide 2026 (Québec.ca, in French, read on November 11, 2026) and the Airmétic Soya HP data sheet (Huntsman). The decision always belongs to the Ministry, on a complete application.

FAQ

Your questions about the cathedral ceiling

How do you insulate a cathedral ceiling with spray foam?

We spray the foam into the cathedral ceiling, where a ventilated attic has no place. It insulates, stops air and holds back vapour in a single application, at about R-6 per inch. The full technique is in our guide.

What spray foam thickness for a cathedral ceiling?

Rénoclimat requires R-40 in total, of which R-20 added: 7 in. of spray foam if there is no other insulation, at about R-6 per inch. If some insulation that counts is left in place, you need less. We confirm the thickness with you before the work.

Does Rénoclimat pay for cathedral ceiling or flat roof insulation?

Since October 1, 2026, Rénoclimat provides $1.75 per sq. ft. once R-20 is added and R-40 reached in total, over at least 300 sq. ft., up to $2,000 for a house. It requires an RBQ-licensed contractor and their compliance certificate. The decision belongs to the Ministry.

Does LogisVert pay for roof spray foam?

No. LogisVert gives nothing for spray foam: for spray foam, the program is Rénoclimat.

Is the $2,000 cap shared with the attic?

Yes. For a house, $2,000 applies to the whole roof, attic included, and $5,000 to a duplex, a triplex or an apartment building. If the roof has several types, the amount is calculated pro rata.

Does spray foam have to be covered inside?

Yes. Inside, the manufacturer's data sheet requires the foam to be covered with a code-compliant thermal barrier, drywall for example. The quote states the covering and who installs it.

A cathedral ceiling or a flat roof to insulate?

An expert comes to your home, measures the roof, works out the thickness with you, then hands you a detailed, firm-price quote on the spot.

Get my detailed quote 1 877 445-4610